Home > Knowledge > Content
Safety rules and technical requirements for large machining
- Dec 31, 2018 -

Large-scale machining is very important in the process of processing. Everyone needs to follow the relevant standards and requirements, so as to ensure the precision of the machining, so that the fittings with the right size and shape can be produced, so that our work can More continuous and normal progress will not cause too much impact and loss.

Large-scale machining technology is to use the corresponding processing methods to process the mechanical parts, so that their shape, size and properties are in line with the corresponding standards, mainly including roughing, finishing, assembly, inspection and packaging, as long as everyone Ensuring the precision of each process will make the finished product more standardized and reasonable, and ensure that it meets relevant standards. So what large-scale machining technology do you need to master during the processing?

1. Remove the scale on the part, and the appearance of the machined part should not be scratched, scratched and other defects.

2. When the assembly is too heavy, it should ensure that its shape, length and temperature meet the relevant standards, and at the same time ensure the sealing of the entire system, so as not to affect the assembly hydraulic system.

3. During the assembly process, it is best to avoid bumps, scratches or rust on the parts, which affects the large-scale machining process, which affects the performance and damage of the products, so that our work cannot continue normally. .

Safety rules for large machining

1. The safe operating procedures of the machining center must be observed.

2. Before work, wear protective equipment, tie cuffs, large-scale machining technology, not wearing scarves, gloves, ties, aprons, and women workers should be in the hat.

3. Check whether the tool compensation, machine zero, workpiece zero, etc. are correct before starting.

4. The relative position of each button should meet the operational requirements. Carefully prepare and input the NC program.

5. To check the operation status of the protection, insurance, signal, position, mechanical transmission parts, electrical, hydraulic, digital display and other systems on the equipment, the large-scale machining process can be cut under all normal conditions.


Related Products